Optionally enter an SNS topic ARN to which Lambda errors and successful disk replacements are published. Requires a minumum of 8 characters and must include at least one uppercase, one lowercase, and one special character.ĭo not change unless a newer version of Qumulo is being used. Qumulo CloudWatch metrics and monitoring configuration Parameter label (name) Optionally enter the ARN of an SNS topic that receives messages when an instance alarm is triggered. (Optional) Qumulo instance recovery topic Set to x.x.x.x/32 to allow one specific IP address access, 0.0.0.0/0 to allow all IP addresses access, or another CIDR range.
Dash (-) is allowed if not the first or last character.Īn IPv4 CIDR block for specifying the generated security group’s allowed addresses for inbound traffic. Name must be an alphanumeric string between 2 and 15 characters. Choosing an invalid key name causes the instance to fail to launch. If empty, the default Amazon EBS key is used. Aliases must begin with alias/ followed by the name, such as alias/exampleKey. Use either a key ID, Amazon Resource Name (ARN), or an alias. The AWS Key Management Service (AWS KMS) key to encrypt the volumes. (Optional) Amazon EBS volumes encryption key Qumulo file data platform configuration Parameter label (name)ġ TB All Flash or 12 TB Hybrid (Flash First architecture with st1 backing disks).ĮC2 instance type for Qumulo nodes. Must be an IPv4 address followed by / and a subnet mask of 0-32. Must be specified as an IPv4 address followed by / and a subnet mask of 0-32. AWS network configuration Parameter label (name)Īll resources are created in this Availability Zone.
Parameters for launching into a new VPC Table 1. To view the created resources, see the values displayed in the Outputs tab for the stack. When the status is CREATE_COMPLETE, the Studio Q deployment is ready. Under Capabilities, select the two check boxes to acknowledge that the template creates IAM resources and might require the ability to automatically expand macros. On the Review page, review and confirm the template settings. On the Configure stack options page, you can specify tags (key-value pairs) for resources in your stack and set advanced options. When you finish reviewing and customizing the parameters, choose Next. For details on each parameter, see the Parameter reference section of this guide. For all other parameters, review the default settings and customize them as necessary. Provide values for the parameters that require input. On the Specify stack details page, change the stack name if needed. On the Create stack page, keep the default setting for the template URL, and then choose Next.
0 kommentar(er)
